Unstable readings do not always mean the sensor is defective. In many projects, the cause is a bubble on the sensing surface, the probe being too close to the container bottom, a dirty optical window, a dry electrode, or cable stress during installation.

Short Answer

Start by checking bubbles, probe position, cleanliness, cable condition and stabilization time. Most water quality sensors should be placed away from the bottom and side walls, fully in contact with the sample, free of bubbles, and allowed to stabilize before calibration or recording.

Bubbles Are a Common Hidden Cause

Bubbles can attach to optical windows, fluorescent membranes, glass bulbs and electrode surfaces. They block contact between the sensor and the water sample, so the reading may jump, drift or respond slowly.

Before measurement or calibration, gently move the probe in the solution, tap the housing when allowed, and visually check that no bubble is trapped on the active area.

Check the Distance From the Bottom and Walls

For many sensors, the probe should not be too close to the bottom or side wall of a beaker, tank or channel. Turbidity sensors should be at least 100 mm away from the bottom and wall during testing. Optical dissolved oxygen probes should keep the membrane cap more than 10 cm from the bottom in laboratory tests and more than 30 cm in field tests.

Conductivity and ion electrodes also need enough clearance so the electric field or membrane area is not influenced by the container.

Dirty Measuring Surfaces Cause Slow Response

Optical sensors depend on clean windows or optical paths. pH and ORP electrodes depend on a healthy glass bulb or platinum surface. Conductivity electrodes need clean contact surfaces. If the active area is covered by biofilm, mud, oil, scale or residues, the reading may become slow or inaccurate.

Use clean water, a soft cloth or a soft brush. Avoid scratching optical windows, fluorescent membrane caps and sensitive glass bulbs.

Cable Stress and Water Ingress Should Not Be Ignored

Non-waterproofed wiring terminals must not be submerged. During installation, the cable should not be tensioned or rubbed against hard objects. Cable jacket damage can lead to water ingress, internal wire breakage and intermittent readings.

If a reading becomes unstable only when the cable moves, inspect the cable base, jacket and connector immediately.

Related YexSensor PDF Guides

For calibration commands and model-specific handling notes, see the Water Quality Sensor Calibration and Usage Precautions PDF and the Water Quality Sensor Usage and Maintenance Instructions PDF.

Need Help Selecting or Maintaining a Sensor?

Tell YexSensor your water type, target parameters, installation method, communication interface and maintenance conditions. We can help you choose a suitable sensor model and prepare practical operation guidance for your site.